The blinking LoopBe Internal MIDI output port 11 LED seems to indicate that something is leaving MIDI-OX, but the lack of responsiveness to LoopBe Internal MIDI in Ableton suggests otherwise. It's also not clear to me whether anything leaving MIDI-OX either. So it seems like data is arriving at MIDI-OX, but something is going wrong once it gets there. I can however still run the ES-1 (and other MIDI devices) directly into Ableton successfully via Pro24 MIDI, so I don't think there's anything wrong with the device, the MIDI cable, the Saffire Pro24, or Ableton. Also, no information arrives in Ableton via LoopBe Internal MIDI. In the Input Ports section, none of the LEDs in the MIDI-OX Generated Event row blink at any time, but I don't remember if this was the case when everything was working before. My other MIDI devices cause LEDs to blink under their respective ports as well. The RT LEDs in the Pro24 and LoopBe rows are constantly blinking, and turning knobs on the ES-1 causes the LEDs for port 11 to blink in these same rows, seemingly indicating that data is arriving at MIDI-OX. The MIDI Port Activity window in MIDI-OX has three rows of LEDs two rows in the Input Ports section (Saffire Pro24 MIDI and MIDI-OX Generated Event) and one row in the Output Ports section (LoopBe Internal MIDI). #Ableton midi monitor pro#Rebooting (Win7 Pro 64bit) didn't solve anything. Today that didn't happen, and indeed, no information appears in the MIDI Status window when I use the ES-1 either. #Ableton midi monitor software#Usually, I open MIDI-OX, turn on the ES-1, and see information flowing through the input/output monitors in MIDI-OX, indicating that the software is receiving data from the hardware. It's very convenient to use MIDI-OX to translate and map the distinct NRPN values coming from each knob to different CC numbers. without using MIDI-OX/LoopBe1, I can run the ES-1 straight into Ableton, but all of the knobs send data on CC6, which obviously has limited usefulness. NRPN commands from the ES-1 go through a Focusrite Saffire Pro 24 interface, are translated to CC commands and routed to LoopBe Internal MIDI within MIDI-OX, and finally taken as input to Ableton. I've been using MIDI-OX (7.0.2.372) and LoopBe1 to translate NRPN input from an old Korg ES-1, and send it to Ableton Live to control various parameters. Topic: data arriving at MIDI-OX, nothing in input monitor (Read 4895 times) Questions and Discussion (Moderator: Jamie OConnell)ĭata arriving at MIDI-OX, nothing in input monitor « MIDI-OX User Forum - data arriving at MIDI-OX, nothing in input monitor »
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |